Se-electronics Voodoo VR2 Manuel d'utilisateur télécharger pdf

VR2 – Technical Information

The Voodoo Ribbons from sE are new for 2010 and mark a new era for Ribbon mic technology – until now

the only Ribbon mic in the world to perform across 20Hz-20KHz was our own Rupert Neve collaboration,

the RNR1, critically acclaimed as the best Ribbon mic in the world. This was achieved using state of the art

transformers and a Rupert Neve designed circuit board to reveal HF usually absent.

The Voodoo mics however achieve full frequency response using a new mechanical device (patent

pending), designed by Siwei Zou, the company CEO. This extraordinary technical achievement allows the

traditional Ribbon capsule to develop and capture frequencies from 20Hz to 20KHz like no other Ribbon

on the planet.

The sound is revolutionary; where the RNR1 is simply a stunning mic in its own class entirely, the Voodoo

range brings traditional ribbon sound to the project and commercial studio, but extends it to perform as

well as most condensers do. The result is superbly detailed and wonderfully open and natural sounding

recordings of acoustic instruments and guitar cabs.

The VR2 is an ‘active’ version of the VR1, which is the more traditional ‘passive’ Ribbon design.

These mics’ unique ability to perform, coupled with searingly good looks, is sure to make the VR1 and VR2

classics of their time.

Technical Specications

Acoustical operating principle

Pressure Gradient with

Active Electronics

Output Impedance: 200 Ohms, balanced

Directional pattern: Figure-8 Rated Load Impedance: 1K-Ohm

Generating Element:

2.5-micron aluminum

ribbon

Maximum SPL: >135dB

Magnets: Rare Earth Neodymium Current consumption

(P48, IEC 61938) :

2mA

Frequency range: 30 -18,000 Hz +/- 3dB Matching connectors: XLR3F

Sensitivity at 1 kHz: 10mV/Pa Weight: 325g

Self-Noise: < 20 dB Dimensions: 33mm L X 17mm W X

183mm H

1) According to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS

2) Measured as equivalent el. input signal

Polar pattern and Frequency Chart

Figure of 8

sE Electronics

www.seelectronics.com

VR2 – Technical Information 1

Résumé du contenu

Page 1 - VR2 – Technical Information

VR2 – Technical InformationThe Voodoo Ribbons from sE are new for 2010 and mark a new era for Ribbon mic technology – until now the only Ribbon mic in

Commentaires sur ces manuels

Pas de commentaire

Se-electronics Voodoo VR2 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Microphones Se-electronics Voodoo VR2. sE Electronics Voodoo VR2 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Microphones Se-electronics Voodoo VR2